Workshop Overdrive #9

Exams are over and we are back to the workshop, again. However, since it's only like the 3rd day of our semester break, not everyone is back yet. Nonetheless, work must go on. Today was pretty much all about KERS as we can finally see it on the vehicle. The video of KERS running is on our Facebook page.

Sam doing some fine-tuning

Bearing holders and shaft.

KERS installed but without the support yet

Some minor adjustments to the supports

It's ready to roll!

Meanwhile, the team manager is busy with the pedal system which is giving him quite some headache. Driver's right foot is a little too big. Haha...

"Should be ok, I think?"

Drill only la...

So many holes but no rivets. Couldn't find them.

Tomorrow is a public holiday (Wesak Day), so there will not be any update. Have a great day tomorrow!